Food and Drug Administration (FDA) Disclosure:

The statements in this forum have not been evaluated by the Food and Drug Administration and are generated by non-professional writers. Any products described are not intended to diagnose, treat, cure, or prevent any disease.

Website Disclosure:

This forum contains general information about diet, health and nutrition. The information is not advice and is not a substitute for advice from a healthcare professional.

BHO Help

Discussion in 'Marijuana Consumption Q&A' started by Special_K_2012, Oct 22, 2014.

  1. #1 Special_K_2012, Oct 22, 2014
    Hi guys, so long story short I need help making some wax. I've done it probably 5 or 6 times and have only gotten good product twice off pure luck. I don't have professional equipment, I usually just do a hot water bath over a skillet. My temp is set from 110-120, and now for some every time I shoot butane through, it just sticks to the pan like I can't even get it off with a razor blade. I can't get my product to bubble during its purge, it'll do the initial bubble reaction after the butane comes out the tube but then when put on the purge it won't do anything. Can you guys help plz! I attached a pic of my set up and how the BHO just sticks to the pan and a pic of my last (highly toxic) batch. I usually blow a quad at a time when doing a run. 
     
    I've read a ton of forums, watched videos, everything and I just can't seem to get it. I'm not buying a vac purge until I get the technique down because whats the point of buying a vac if my product is green/black poop when I could just buy golden goodness from the dispensary?
     
    Please help me out guys, it really sucks when your 1st batch ever turns out golden cheese looking to black/green goop every time :/

     

    Attached Files:

  2. #2 Dr.Fumbles, Oct 22, 2014
    Are you freezing everything overnight before blasting? are you using high grade material? get a vac pump/chamber and a proper heat source that will hold a temp as low as 90 degrees.
     
  3. #3 Special_K_2012, Oct 22, 2014
     
    I am freezing, material isn't the best but I doubt my end product should be this bad. Do you have any vac chambers to recommend?
     
  4. #4 Dr.Fumbles, Oct 22, 2014
    Vac-it-pro chambers. starting material has a lot to do with color, You need good bud to get good color unless you winterize
     
  5. #5 DabsOnTheMountain, Oct 22, 2014
    If you don't have a vac then why not make QWISO with ethanol. Safer then iso without a vac chamber, MUCH safer then BHO without a vac chamber.
     
  6. #6 chinesei's, Oct 22, 2014
    Is this a close loop system? If not, Stop blasting then.
     
  7. #7 Dr.Fumbles, Oct 22, 2014
    Why should he stop if he doesn't have a cls?
     

Share This Page