Ideas on how to make into a bong

Discussion in 'Smoking Accessories Q&A' started by chronicschwag, Apr 13, 2014.

  1. #1 chronicschwag, Apr 13, 2014
    Last edited by a moderator: Apr 13, 2014
    I need ideas on how to turn this into a bong.
    There is a pocket that doesn't have a hole in it in the middle of the bong, you can put a lid on it and hold herb.
    20140412_1851121.jpg
    20140412_1839211.jpg
    sorry the pics are sideways, don't know how to turn them

     
  2. #2 plastikboy, Apr 13, 2014
    Last edited: Apr 13, 2014
    you  could just make abowl out of wood(<best option)/foil/plastic(<worst option) stick it in that spout with blutack to seal it, then fill up with water just past the bottom of the spout, check if it bubles ok and that you dont get water in your mouth and if it does your good to go
    that would actually be a bad ass bong if it worked with that compartment for herb inside of it
    what is that even off?
     
  3. #3 chronicschwag, Apr 13, 2014
    Its a jiny bottle(idk how to spell jiny)
    I was thinking about getting a downstem made for it because it's so dope and the weed holder has a lid

    Sent from my SAMSUNG-SGH-I747 using Grasscity Forum mobile app
     
  4. #4 plastikboy, Apr 13, 2014
    you dont need a downstem,, its built in, cant you see it?
     
  5. #5 chronicschwag, Apr 13, 2014
    But it gets to heavy with all that water I made one out of rubber hose but there's too much drag

    Sent from my SAMSUNG-SGH-I747 using Grasscity Forum mobile app
     
  6. #6 plastikboy, Apr 13, 2014
    really? thats a surprise, It must be bigger in person , and plus that compartment takes up some water space too
     
  7. #7 chronicschwag, Apr 13, 2014
    Yeah I wanna just get that pour tip/downstem taken off then fit a bowl in that hole

    Sent from my SAMSUNG-SGH-I747 using Grasscity Forum mobile app
     
  8. #8 plastikboy, Apr 13, 2014
    Last edited: Apr 13, 2014
    its up to you but if i were you I wouldnt mess with it, glass shatters..easy. removing that stem and fitting a bowl is MUCH easier said than done. removing that stem and fitting a bowl and having it air tight is a pro job
     

Share This Page