Food and Drug Administration (FDA) Disclosure:

The statements in this forum have not been evaluated by the Food and Drug Administration and are generated by non-professional writers. Any products described are not intended to diagnose, treat, cure, or prevent any disease.

Website Disclosure:

This forum contains general information about diet, health and nutrition. The information is not advice and is not a substitute for advice from a healthcare professional.

Making QWISO Hash

Discussion in 'Seasoned Marijuana Users' started by phillysmoker92, Jul 20, 2012.

  1. #1 phillysmoker92, Jul 20, 2012
    My grinders have been dirty as crap recently, so I decided to clean them out and try to make some QWISO. I cleaned out both of my grinders in 91% isopropyl. Then I dumped the alcohol into a sheet pan to dry out, and set a fan on it. As it was drying, however, it acquired a slightly milky color and opaqueness. Is this normal?

    Anyway, the fan is still blowing, and the alcohol is still evaporating. I am going to wait another several hours, but does anybody have any tips or suggestions?
     
  2. #2 Bmurphs, Jul 20, 2012
    Yeah that sounds normal, it'll clear up as more alc evaporates. Qwiso made this way is typically going to have a lot of impurities so that may be part of the reason. I'd let it evaporate for 24 hours total if you aren't using a heat source to accelerate the process. After that take a razor blade, scrape it up and enjoy!
     
  3. #3 l James l, Jul 20, 2012
    Give it 24 hours before you scrape it for sure.
     
  4. #4 SIRSOG, Jul 20, 2012
    i would dissolve it back into iso and filter it and re-do the evaporation

    and by sheet pan, do you mean a metal pan?
     

Share This Page