I've searched and searched and I need help trying to understand how to make Liquidy Hash Oils.
I've made QWISO hash and yes it's soft, but it's not a full liquid.
The reason why Im looking to make liquidy hash is because I've been smoking wax from an ecigg pen that I bought. It's normally used for oils but I still loaded some wax and was able to smoke it.
Just figured refilling the tank with liquidy hash would be much more effective regarding packing wax.
After I wrote the big ass explaination below, I went to look this up and I found something really cool! Teflon paper or bags. (see http://www.youtube.c...h?v=Z4WsMHcMKrg)
all you have to do when it is cooled and vaped is peel it off the paper and fold the oil in pieces and just slip it into the vial. Then heat the vial and it will melt.
Try making it with rum 150, I know it is more polar than you want and some plant material will seep in, but the great thing about using everclear or rum is you don't have to evaporate all the solvent. You can wait until it is close to being evaporated - but still liquid somewhat and pour it into the vials. You can leave it at that or you can leave the vials open for further evaporation.
or, as it get close to evaporating the chemical solvent , add the run or everclear at the end of the evaporatiob cycle. This can be a little touchy though, because you won't know when your original solvent was completely through evaporating/
also, and I havent tried this, but perhaps wait until it becomes tar resin (solvent completely evaporated) and then heat up the dish again and pour the rum in. I wonder if that would work to make the oil loosen up better from the dish after total evaporation?
I would NEVER use a chemical solvent like methane or butane as a thinner.
First: it is no good for the liver and lungs
Second: it makes the oil smell bad
Third: it is highly flamable and if someone lights a match while the butane or methan are active, it will start a fire.
Edited by oldsmoky, 04 November 2013 - 12:05 PM.