Make a vaporizer...

[PaRaDoX]

I found these instructions online, but I couldn't figure them out. I was wondering if someone would try it and take pictures, so I can see how to do it. I also don't see how it would be a vaporizer though.

How To Build A Simple Yet Effective Marijuana Vaporizer

They are by far the best way I have smoked weed and are not hard to make.

Simple Vaporizer Plans
These are plans on building a simple vaporizer out of a soldering iron, some wood, and a plastic 2 litre bottle.

Of course not everyone has the skills, tools, or time to make their own vaporizer. Fortunately it is possible to buy vaporizers!!


The Simple Yet Effective Vaporizer
First you will need the following materials:

-- A soldering iron (12v adapter)
-- Flat piece of wood (any wood about 1/2 inch thick...at least 8 inches X 8 Inches)
-- Wooden Dowels (long at least 22 inches and about 1/2 inch diameter)
-- A plastic 2 liter bottle (the kind with the black part on the bottom)


Procedure:
First cut the flat wood into a triangle with equal 8 inch sides (60 deg. angles)

Second Stain and varnish the wood (or polyurethane).

Choose one side of the flat triangle to be the top Find the exact centre of the triangle and mark it on both top and bottom.

Choose a drill bit size such that the soldering iron handle can be set into the hole created by the drill and have the rim on the top (handle end nearest the element) sit on it so it doesn't fall through.

Drill with this size bit through the center of the triangular piece.

Turn the triangular piece over and mark 3 spots each about 1 inch from the vertex each angle.

Drill through each of these at a 15 degree angle with the smallest bit that the size dowel you have will fit into (snug is good).

Turn the triangular piece to the top.

Pull the plastic bottom piece off of the 2 litre bottle Cut out the middle of this piece (the indented middle part).

Place the black piece over the hole in the centre of the wooden triangle and put a two nails through it into the wood.

Use Hot Glue (or better Silicon sealant) around the bottom of the black piece and fill in any cracks in it made in the removal from the bottle.

Place some wood glue in each of the holes on the bottom of the triangular piece.

Put a dowel in each of these holes and gently tap them with a hammer to set them (then let the glue dry).

Put the soldering iron power cord through the hole in the middle (trim the plastic if you have to).

Pull the soldering iron through so that it rests on the base...sticking up into the air.

Cut out the bottom of the 2 litre bottle (make a nice hole as big as you can but so that it still will go into the black piece and fit (leave some of the curved bottom).

That’s it...now just fashion a bowl and your all set.
--------------------------------------------------------------------------------------------------------

I have also read that if you take a old light bulb, cut the end off, crush up your weed, put it in there, use a lighter to light bulb on the outside, and it cooks the weed instead of burning it. It sounds like a meth pipe to me...

[RollinNGreen21]

There is a site with the exact same instructions along with pics. I can't remember the site though. But it does exist.