Water Bottle Bong Directions?

[Mstrbakeo]

Hey,
Ive been trying to making my own water bottle bong, but everytime I try it never works it always comes out all messed up. If anyone would be so kind to post a step by step guide to water bottle bong construction it would be greatly appreciated. Thanks.

[PassDaDutch]

take the bottle and get something long and metal and burn the plastic so it bubbles and shove the long metal piece in there and connect a socket to it and thatll be ur bowl create a car fill with water and tokemaking the plastic just bubble and pushing it through the plastic will make it air tight since itll seal and just take the cap off and toke away

try not to use a pen or aluminum as they are both bad for u

[JeraldoRonaldo]

Yeah, try a soldering iron for the hole melting.

[sigh]

is it safe to use an aluminum rod, like a tv antenna type pole?

[pothead_420]

i use to make them all the time...heres how i do them

1.take a water bottle adn about 3/4 down poke a hole the size of a pens diameter
2.take a bic pen (just the white ones that are blue black or red) and take the ink out, adn then i take a scissors and cut off the back thing (the little plug)
3.take a socket wrench socket adn find one that fits the pen
4.stick the pen through the whole so its in the bottle, and then tape it so it stays in place adn is tight
5.then make a hole for the carb
6.back bowl
7.you know what to do after that

i hope this helps

[SanDiegan]

Here is the best way..

1. Get a bottle of water.. empty it completely (into a cup so you can drink it later )
2. Take your lighter and burn a small hole through the plastic. Make the hole slightly bigger than the pen.
3. Wrap a thin strip of duct tape (slit the thing in half) around where the pen will be in the hole.. You're gunna hafta jam it in the hole but it gets rid of almost all leakage.
4. Make hole for carb
5. Yeah.. smoke..


Sometimes the lighter bends the bottle, but i think that just makes it easier to hold :P

[hoast]

Get a bottle, and do the lighter thing... I hold the lighter about 11 seconds.. the plastic will get bubbly, and have a tiny tiny tiny hole, then shove in a pen/tube.. this way, it will melt back onto the tube so it will be sealed.. if its not sealed, take some plastic tape and surrond the pen, then melt the tape around the hole/pen so it seals it.

[Mstrbakeo]

But after sticking the pen or tube into it where/ in what do you put the weed? Doesnt the bowl go on the end of the tube? What could you use for that?

[popsson]

i put tape over the hole and then poke a hole thru the tape and stick the pen thru.

use duct tape.

[hoast]

Make a tinfoil cone and put the weed in there..