How to make Pixie Dust-CannaFlour

Here is a recipe I can across today. ENJOY!!!

Making Canna-Flour AKA: Pixie Dust

You will need:

One table spoon of butter or oil
Four cups dried, finely ground and sifted cannabis leaves
Large cast iron or thick bottom steel pan
A big spoon

Put your pan on the largest element at the lowest possible setting. An electric stove works best.

Melt the butter. Add the cannabis slowly. You will have to smear it on the bottom of the pan to get it even.
Eventually it will saturate it. The idea is to get it slightly damp, not wet.
You will notice it fluff up as you add more and more cannabis.

Stir often, more often if you have a gas stove, for at least an hour.
When the mixture first hits the pan, it has a starchy, green smell and it can make you sneeze.

After a while in the pan, the molecules start to re-form into more pleasant smelling.
You are done when the mixture is fluffy to the touch and smells sweet, sort of like fresh bread.
After you have done it a few times, you will know the smell exactly and be able to judge it better.

Suggested dose is about one teaspoon, put it in anything you can!

*Kelly*

 

Yes, proud to say, I do.

 

Yes, use the flour just like you would with any recipe.
same goes for the canna butter