Aero cloner

[Konon]

If I were to use an aero cloner, what do i basically do?

I know to cut the clone, dip it in the root compound... but what from there? Do I just stick the end into the cloner and turn the sprayer on 24/7 or should i have it on/off every 15 mins? Do I just use pH adjusted water, no nutes or add superthrive?

Answers to questions and details would be loved. Thanks.

[Konon]

bumpp

[Konon]

Nobody use an aeroponic or hydroponic cloner that can help me?

[prime mover]

1. Take your 2 to 4 inch long cutting and remove your bigger leaves

2. With a clean sterile blade, re-cut the bottom of the cutting at a 45-degree angle (I do this cutting under water to prevent embolisms)

3. Place your clones in the neoprene inserts

4. Place the cloner 1 to 2 feet below your lighting (I use fluorescent lighting for cloning but stick to what works for you)

5. Fill the reservoir with purified water

6. Add one ounce of cloning solution (not cloning gel - I use Clonex) per gallon of water or whatever your solutions label recommends

7. Add 2-5 ml of Hydrogaurd per gallon of water (this is not super important but I still follow this step to reduce algae build up)

8. Adjust pH level to 5.8 to 6.2

9. If possible, maintain the solution temperature around 72 to 77 degrees Fahrenheit

10. Run clone machine 24/7

11. Mist leaves with water once or twice daily

12. Clones should root within 3 to 10 days

Hope this helps!!

PM

[Swa_Swa]

Nice guide for cloning machines. I forgot the part about using some kind of cloning agent in the water.

[Konon]

Hah, ya i saved the post in a words document for later use. +rep prime