how can you fix a small hole in a bong? (pic included)

Discussion in 'Bongs, Dab Rigs, Bubblers, Water Pipes' started by gubs, Jul 9, 2011.

  1. #1 gubs, Jul 9, 2011
    sorry if this is a repost! i posted this thread a little while ago and haven't seen it yet.
    i recently bought a black leaf 6 arm perc bong only to discover it has a hole.
    the hole is located where the main chamber connects to the chamber with the 6 arms. if any of you are familiar with BL 6A you'll know there's a carb hole. the hole is an inch above the carb hole so i can easily reach it with a paper clip or a syringe.

    the hole itself is maybe 2-3mm is diameter. because it connects both chambers, all the water drains into the main chamber where the down stem is.
    is there anything i can use to repair this hole or should i just get a replacement?

    here's the pic, you can see the hole right below one of the arms.
    [​IMG]

    irrelevant side thought, the hole acts like a 7th arm.i guess i got a 7 arm BL bong :p
     
  2. #2 gubs, Jul 10, 2011
    *cough*
     
  3. #3 Verdurous, Jul 10, 2011
    Waterproof tape?
     
  4. #4 RollinindaRoyce, Jul 10, 2011
    UMm you need to find a blower. Thats my only answer
     
  5. #5 2724, Jul 10, 2011
    Mighty putty!
     
  6. #6 bammerman, Jul 10, 2011
    Last edited by a moderator: Mar 15, 2016
    ^^^^ done it. Works great so far.^^^^
     
  7. #7 budsmokn420, Jul 10, 2011

    Was thinking the same thing!

    Also you can put some tape over it or just hold the hole with your finger when you rip it.
     
  8. #8 smilyagent, Jul 10, 2011
    2 part epoxy at ace will work great
     
  9. #9 buriedonglass, Jul 10, 2011
    Wait, you can actually see what's going on in that pic? I can't...
     

Share This Page