Noob just started !

[richirich_99]

you need to be watering them with distilled water, or getting some ph down and bring your ph down before you water them. a ph of 9 is WAY too high for them, should be between 6.5-7.0

[nativelabs]

Cheers RichiRich !

I'm aware of that thanks. We have a PH kit which is colour coded, but it's difficult to judge what PH it actually is. It's certainly around 6 that we are watering with, but whether it's 5.7 or 6.3 we can't be sure as the kit isn't accurate enough. We don't water with PH9 - we use PH Down to adjust and use the kit to measure.

There was no watering yesterday at all and it will begin again this evening.

They are still a bit droopy but not as bad as they were.

[nativelabs]

Hi All,

We need help !!!!

They are drooping again after the watering last night.

We've also noticed a really really small yellowish spot on the end of one of the leaves of the smaller one.

Are we really overwatering them or is it something else?

Cheers

[IMgreen]

got a pic?

[maddcatone]

I Really Wish I had a whole room to devote to this. Congrats bro. Hope you and your girl enjoy, because you look like you'll have a great grow room once you get that temperature thing taken care of.

As for C02 production, and if you can't afford those pricey CO2 injection systems, An easy way to make one is:

Take:
- a 5 or so gallon (not sure the metric of top of head) gas can or container which you can seal tight.
- Some fish pump hosing
- a small pale or bucket with about 2 inches or so of water in the bottom.
- Yeast (look on packaging for mixture details), Sugar, and Water.

Cut a whole in the cap of the gas can or container, about the same thickness (A little on the tight side) and fasten the hose into the cap (such as =[ = ) with some duct tape of something (Be creative). Fill the tank with the yeast (the appropriate amount of course), then add your sugar water mixture and screw the cap on. *MAKE SURE YOUR MIXTURE END OF THE HOSE ISN'T SUBMERGED IN YOUR MIXTURE OR YOU WILL GET THE JUICE BOX EFFECT AND MAKE A TOTAL MESS* Place the loose end of the hose into your water bucket and you should see bubbles. These bubbles are CO2. Place them with your plants and they'll be enjoying a fresh supply of CO2 for days, until you reload it with a new mixture. You could even place the reservoir outside the shower and place the bucket in between your plants to optimize the space you have. I like your setup. Good luck!