[screwdababylon!]

installed a filter
then one i thought to make was too small and the fan was too powerfull so the air was going immediatly through the wery thin filter and didnt get cleaned at all

i choose the traditional one this time and took as a model "can 33"
dimentions:

CFM: 300 (180 true)
lenght: 20"
inner core: 6"
outer core: 9"
bed width: 1.5"
weight: 23 lb

DONT HURRY TO MAKE THE SAME ONE
THIS IS AN EXPERIMENTAL MODEL
AND HAVE TO BE APPROVED IN THE END OF THE FLOWERING)

ive found a formula that gave me all the dimentions
and i would recomend it as a basic thing to start with
and maybe correct it a bit as needed
the filter is working well
and it sucks air even on the lowest speed (about 100CFM)
so i can run it like that untill its not too hot

i had to remove my wonderful partition
and take the ballast out of the cab (its now on the roof)
and the fan itself is on the back of the cab

U CAN AVOID THIS EASELY
BUT I DIDNT CARE MUCH - SO I DID IT THAT WAY

check out the pics
u can see my babys flowering there (grow #2)
the cab is working perfectly!!!!
+ rep to myself)))



l