Has anyone ever smoked a blunt that was 100% cannabis?? A few nights ago, the only buddy I have that grows came over with his girl to smoke some ganj. My girl was there too, so we had 4 people throwing down. (Well, really only 2 seeing my girl and his NEVER pay for herb...but thats besides the point.) We were smoking on the Kushage he grew from T.H. Seeds.... and some hash oil made using the butane method that was a combination of heady nugs/keif/leaves. My buddy knows I have some plants veggin and suggested rolling a blunt in a fan leaf.
It was awesome. I suggest anyone who's reeeeally into weed to try this out. Its especially cool if all the materials were homegrown. The main reason I'm posting this thread is to see if anyone has done this before...and more so, if they know how to. And if they do, if they have instructions or tips on how mine can be better. My buddy likes to be a douche and won't tell me exactly how to do it. I was half watching him, half watching 12 Monkeys, and half fooling around. Too many halves to know exactly how to roll it, but I remember a little from watching him and what he was saying during. Afterwards I attempted to roll my own.... quite unsuccessfully. However I have since rolled 3 that came out very nice.
First and foremost (duh) break up the bud have it ready. For this, and like any blunt, the bud needs to be well ground and without stems. We don't want little holes poking out. And it helps to use dank.....just because, personally... I like to get high when I smoke.
Second, I don't know if its possible without using has oil as a glue/stabilizer. I'm sure other substance would work, but then it wouldn't be 100% cannabis.
Ok...ya know how a living weed leaf will become 'soft' before drying/burning when it is exposed to heat?? Well thats how the fan leaf needs to be for optimum control. So take a large fan leaf and cut off each finger as close to the stem as possible....the 2 largest fingers are used.
Take the smaller of the fingers first and put the herb in it as if it were a normal blunt. Roll the bottom half under the top half like a normal blunt, but smear a little hash oil on the underside of the top half and on the top of the bottom half. **The oil goes in the same place the licking glue is on rolling papers** Once the first leaf is rolled relatively tight, (first wrap doesn't need to be perfect....just well contained) smear a small amount of oil over the seams and a decent amount all over the whole blunt.
**The leaves need to be soft....not fully alive and before they start to become dry.**
Before rolling up the second leaf finger, smear some hash oil over what will be the inside of the leaf. Now take the oil apllied, second, bigger leaf finger and start rolling it over the blunt. Start by covering the seam of the first leaf with the second leaf and then roll it up tight. Once again, use the hash oil as if it were the glue on a rolling paper. I can't express how useful and important the hash oil is. Unlike blunt wraps/cigars, the leaves haven't been rolled and packaged for months.... normal blunt rolling materials already have a curl to them and the marijuana leaves can be very difficult to work with.
Once the blunt is rolled, allow it to dry and smoke that bitch.
***IMPORTANT***
- The leaves will be VERY delicate. Removing all stems is a must and extra delicate care is required or else the leaf will rip.
- Make sure the blunt is totally dry before smoking or else it will burn ridiculously uneven due to the hash oil.
- DO NOT apply heat to the blunt to dry it out. Doing so can fuck up all your work.
- DO NOT allow the blunt to become super dried out. This too can fuck up all you work.