
07-08-2006, 09:12 PM
|
|
Registered User
Join Date: Jan 2006
Location: Have a guess
Posts: 338
|
Once that was done I put in the door divider (if that’s what you call it and secured that with modesty blocks and screws.
door partition Resized.JPG
seald &framed Resized.JPG
Today I put up the doors which proved allot more frustrating than I imagined. I’m no carpenter and have very little patience, so this really got on my tits. After I managed to get the doors hung I was concerned still about the light leakage and been air tight.
Went and got more wood and draft seal tape. Basically I knocked up indoor frames and screwed them in place and also chiselling into the frame allowing the door to close properly.
hinges Resized.JPG
Followed by some more bathroom sealant. Still on the inner door out side the frame, I stuck the draft seal tape to be 100% sure.
door fram.JPG
door sealed.JPG
|
|
|
|